Systec has revised its DriveSet M106, M207 and M307 single-, two- and three-axis linear units. The units, which are equipped with a controller, are based on the same basic design and only differ in the working area. Motor technology, linear guides and sensors have been harmonized in all three systems - the systems with the same operating characteristics are configured in a comparable way. With a repeat accuracy of 0.4 mm, a load capacity of 1 kilogram and a speed of 0.4 m/s, the stepper motor systems are suitable for use in light handling tasks. A gripper is often mounted on the end effector point of these DriveSets. This can be set up using the corresponding Xemo controller and the MotionBasic IDE development environment, the Labview graphical programming environment or via Windows DLL in C## or VBA.